Caravan AWD V6-201 3.3L (1991)
Removing Brake Cable From Brake Support Plate
1. Loosen cable adjusting nut and disengage front cable from adjuster. Remove cable housing retainer from anchor bracket, by sliding a 14 mm box
wrench over cable retainer and compressing the three fingers. Alternate method is to use an aircraft type hose clamp and screwdriver. This is
similar to the method shown for removing the parking brake cable from the support plate.
2. Remove cable guide brackets from frame rail and loosen cable housing at pedal assembly.
3. Lift floor mat for access to floor pan and force seal out of hole (into vehicle).
4. Pull park brake cable strand end forward and disconnect button from clevis. Tap cable housing end fitting out of pedal assembly bracket.
5. Pull park brake cable assembly into vehicle through hole in floor pan.
Install
Parking Brake Removal And Install
1. Pass cable assembly through hole in floor from inside vehicle.
2. Install cable retainer into brake pedal assembly bracket and then install cable housing end fitting into retainer.
3. Engage cable strand button into clevis.
4. Install floor pan seal and floor mat.
5. Insert brake cable and housing into anchor bracket making certain that housing retainer fingers lock the housing firmly into place.
6. Install cable guide brackets.
