Caravan AWD V6-201 3.3L (1991)
Intake Manifold: Service and Repair
REMOVAL
1. Perform fuel system pressure release procedure, as follows.
NOTE: The fuel system is under a constant pressure of approximately 330 kPa (48 psi). Before servicing the fuel pump, fuel lines, fuel filter,
throttle body or fuel injector, the fuel system pressure must be released.
Fig. 1 Injector Harness Connector
^
Loosen fuel filler cap to release fuel tank pressure.
^
Disconnect injector wiring harness, from engine harness.
^
Connect a jumper wire to ground terminal Number 1 of the injector harness Fig. 1 to engine ground.
^
Connect a jumper wire to the positive terminal Number 2 of the injector harness Fig. 1 and touch the battery positive post for no longer than 5
seconds. This releases system pressure.
^
Remove jumper wires.
^
Continue fuel system service.
2. Disconnect negative battery cable. Drain cooling system.
Fig. 2 Throttle Body Assembly 3.3L
3. Remove air cleaner to throttle body hose assembly Fig. 2.