Caravan AWD V6-201 3.3L (1991)
Fig. 50 Camshaft Thrust Plate
8. Check camshaft endplay With new thrust plate the specification is 0.0127 to 0.304 mm (0.005 to 0.012 inches.). Old thrust plate specification is
0.31 mm (0.012 in.) maximum. If not within these limits install new thrust plate.
TIMING COVER INSTALLATION
1. Be sure mating surfaces of chain case cover and cylinder block are clean and free from burrs. Crankshaft oil seal must be removed to insure
correct oil pump engagement.
NOTE: Do not use a sealer on cover gasket.
Fig. 46 Timing Cover Rear Surface
2. Use a new cover gasket, O-rings Fig. 46. Adhere new gasket to timing cover, making sure that the lower edge of the gasket flush to 0.5 mm (0.020
in.) passed the lower edge of the cover. Refer to oil pan sealing outlined in this section.
3. Rotate crankshaft so that the oil pump drive flats are vertical.
4. Position oil pump inner rotor so the mating flats are in the same position as the crankshaft drive flats Fig. 46.
5. Install cover onto crankshaft. Make sure the oil pump is engaged on the crankshaft correctly or severe damage may result.
6. Install chain case cover screws and torque to 27 Nm (20 ft.lbs.).
