Caravan AWD V6-201 3.3L (1991)
Fig. 12 Timing case cover gasket & O-rings
3. Install a new cover gasket and new O-rings, Fig. 12.
4. Rotate crankshaft so oil pump drive flats are vertical.
5. Position oil pump inner rotor so mating flats are in same position as crankshaft drive flats, Fig. 12.
6. Install cover onto crankshaft. Ensure oil pump is correctly engaged on crankshaft or severe damage may result.
7. Install chain case cover screws and tighten to specifications.
8. Install crankshaft oil seal as follows:
a.
Position seal into opening with seal spring towards inside of engine.
Fig. 13 Crankcase oil seal installation
b.
Install seal until flush with cover using seal crankshaft seal installing tool No. C-4992 or equivalent, Fig. 13.
Fig. 14 Crankshaft pulley installation
9. Install crankshaft pulley using thrust bearing/washer plate tool No. L-4524 or equivalent and a 5.9 inch screw, Fig. 14. Tighten crankshaft pulley
bolt to specifications.
