Caravan AWD V6-201 3.3L (1991)
Stop Lamp: All Technical Service Bulletins
Stop Lamps/Cruise Control - Malfunction
NO.:
05-08-92 Rev. A
GROUP:
Brakes
DATE
Aug. 10, 1992
SUBJECT:
Stop Lamps Remain Illuminated/Inoperative Speed Control
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 05-08-92 WHICH SHOULD BE REMOVED FROM YOUR FILES. THE
ART FOR THE SPRING HAS BEEN REVISED AND IS HIGHLIGHTED WITH **ASTERISKS**.
NOTE:
THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH BENDIX ABS. (1990 AC AND AY BODIES BUILT AFTER MDH 03-26-XX).
MODELS:
1990-1992
(AC) Dynasty/New Yorker Salon
(AY) Imperial/New Yorker Fifth Avenue
1991-1992
(AS) Caravan/Grand Caravan/Caravan C/V
Voyager/Grand Voyager/Town & Country
SYMPTOM/CONDITION:
Some vehicles equipped with Bendix ABS, may exhibit a condition where the brake pedal may not return to its fully released position. As a result, the
rear stop lamps remain illuminated when the brake pedal has been released or the speed control may be inoperative.
DIAGNOSIS:
Verify that the stop lamp switch is properly adjusted as outlined in the appropriate service manual. Ensure that the accumulator is fully charged, by
pumping the brake pedal (with the ignition key ON) until the pump comes on, then allow it to fully charge the accumulator. Depress the brake pedal and
slowly release it. Verify that the brake pedal does return to the fully released position, by pulling up on the pedal and verify that the rear stop lamps go
out. If the rear stop lamps do go out when pulling up on the pedal, proceed with the repair procedure.
PARTS REQUIRED:
AC and AY Bodies
1
Pedal Return Spring Kit
4723625
Pedal Return Spring Kit Components:
1
Nut, Pedal Shaft
6500197
1
Pedal Return Spring
4723627
1
Clip, Hydraulic Assembly Push Rod Pin
4294036
AS Body
1
Pedal Return Spring Kit
4723626
Pedal Return Spring Kit Components:
1
Nut, Pedal Shaft
6500197
1
Pedal Return Spring
4723628
1
Clip, Hydraulic Assembly Push Rod Pin
4294036
REPAIR PROCEDURE:
This repair involves installation of a brake pedal return spring.
1.
Remove the under dash silencer pad to expose the brake pedal and bracket assembly.
