Caravan AWD V6-201 3.3L (1991)
Supplemental Restraint System (SRS) Control Module: Service and Repair
Removal/Installation
Fig. 45 Airbag system diagnostic module
REMOVAL
1.
Disconnect and isolate battery ground cable, then waist at least 10 minutes prior to performing services.
2.
Remove forward console.
3.
Remove module and bracket attaching screws.
4.
Carefully lift module up and rearward, disconnect electrical connectors, then remove the module.
INSTALLATION
1.
Position module and bracket facing forward, then connect electrical connectors and lock into position.
2.
Using locating tab, place module and bracket on lower bracket.
3.
Install module and bracket supplied attaching screws. Torque to 35 inch lbs.
4.
Install forward console.
5.
Do not connect battery ground terminal. Refer to Air Bag Systems/Testing and Inspection/Procedures for operational check procedure.
