Caravan AWD V6-201 3.3L (1991)
Fluid Filter - A/T: Service and Repair
Fluid Drain and Refill
1. Raise vehicle on a hoist. Place a drain container with a large opening, under transaxle oil pan.
2. Loosen pan bolts and tap the pan at one corner to break it loose allowing fluid to drain, then remove the oil pan.
3. Install a new filter and O-ring on bottom of the valve body.
4. Clean the oil pan and magnet. Reinstall pan using new MOPAR RTV sealant. Tighten oil pan bolts to 19 Nm (165 inch lbs.).
5. Pour four quarts of MOPAR ATF+4 (Automatic Transmission Fluid) Type 9602 through the fill tube.
6. Start engine and allow to idle for at least one minute. Then, with parking and service brakes applied, move selector lever momentarily to each
position, ending in the park or neutral position.
7. Add sufficient fluid to bring level to 1/8 inch below the ADD mark.
CAUTION: Do not overfill transaxle. Do not acid oil if level is between: Lower holes for warm oil (100°F). Upper holes for hot oil (180°F).
8. Recheck fluid level after transaxle is at normal operating temperature. The level should be in the HOT region.
9. To prevent dirt from entering transaxle, make certain that dipstick is seated into the dipstick fill tube.
