Caravan AWD V6-201 3.3L (1991)
8.
Loosen the Low/Reverse band adjustment (refer to Figure 4). Disassemble the Low/Reverse servo (refer to Figures 5, 6 and 7).
9.
Install the revised Low/Reverse piston (P/N 4659837) and reassemble the Low/Reverse servo assembly.
10.
Using an inch-pound torque wrench, tighten the low/reverse band adjusting screw to 41 in. lbs. (4.6 Nm) then back the screw off 3 1/2 turns.
Tighten the lock nut to 10 ft. lbs. (14 Nm).
11.
Attach the valve body to the transaxle assembly, torque the seven attaching bolts to 105 in. lbs. (12 Nm).
12.
Install and torque the neutral start/back-up lamp switch to 24 ft. lbs. (33 Nm).
13.
Attach the parking rod to the valve body with the parking rod E-clip.
14.
Install a new transaxle oil filter & transaxle oil filter gasket (P/N 4269649 & 4269671), torque the 2 attaching screws to 40 in. lbs. (5 Nm).
15.
Apply Mopar RTV Sealant (P/N 4318025) to the mating surface of the transmission oil pan and the underside of the attaching bolt heads. Install
the transmission oil pan and torque the bolts to 165 in. lbs. (19 Nm).
16.
Pour four quarts Mopar Automatic Transmission Fluid Type 7176 (P/N 4467721) through the dipstick opening.
17.
Start the engine and allow to idle for a minimum of one minute. With the parking brake and the service brakes applied, move the gear selector
lever momentarily to each gear position. Place the gear selector lever in either park or neutral.
18.
Add an appropriate a mount of transmission fluid to bring the level to 118 in. (3 mm) below the ADD mark on dipstick.
19.
Recheck the fluid level after the transaxle is at normal operating temperature. The level should be in the HOT range of the dipstick.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
