Caravan AWD V6-201 3.3L (1991)
2.
Pull up slightly on the clutch pedal. This will relieve the spring tension on the positioner adjuster located on the back of the clutch pedal, see
Figure 1.
3.
Remove the auto clutch cable adjuster spring from the back of the clutch pedal, see Figure 1. The lower legs of the spring are bent to lock on the
back of the pedal. It will be necessary to push the locked leg sections over the bottom edge of the clutch pedal where the spring is located.
4.
Check the spring for cracks. If cracks are evident, replace the spring. Measure the spring tension dimension, see Figure 2, with the spring in a
relaxed position.
5.
If the spring is out of the dimension, shown in Figure 2, replace the spring with PN 4188653.
6.
Install the auto clutch adjuster spring on the back of the clutch pedal. Caution should be used as to not bend or damage the spring during
installation.
7.
Lube the teeth of the positioner adjuster, using Lubriplate (PN 4549615) or equivalent, on the back side of the clutch pedal.
8.
Install the clutch cable to the release lever at the transaxle.
9.
Push and lift up on the clutch pedal 2 or 3 times to allow the adjuster mechanism to reset the clutch cable.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
