Caravan AWD V6-201 3.3L (1991)
chamfers will be facing outward from the joint, on S.S.G. joint the internal clip in cross will be facing outward from the housing.
5.
Apply lubricant to ball races between all sides of ball grooves.
6.
Insert balls into raceway by tilting cage and inner race assembly.
Fig. 7 Driveshaft components
7.
Slide small end of boot over shaft, then place clamp over groove on boot.
Fig. 27 Installing circlip. Outer CV joint
8.
Insert new circlip in shaft groove. Do not over expand or twist circlip during assembly. On S.S.G. unit has a reusable circlip retainer that is part of
driver assembly.
9.
Position joint housing on shaft, then engage by tapping sharply with a soft faced mallet.
10.
Ensure snap ring is properly seated by attempting to pull joint from shaft.
11.
Position boot over boot groove in housing, then install clamp.
