Caravan AWD V6-201 3.3L (1991)
4.
Install vent (P/N 4505557) into vent adaptor (P/N 4762499) and tighten to 35 in. lbs.
NOTE:
IF FOR ANY REASON THE SHIFT LINKAGE REQUIRES ADJUSTMENT, THE FOLLOWING PROCEDURE IS PROVIDED AND DOES
NOT REQUIRE THE USE OF A LOCK PIN.
1.
Gain access to the transaxle crossover cable adjusting screw located at the floor shifter in the vehicle interior as outlined in the appropriate service
manual.
2.
Loosen the adjusting screw to allow the crossover cable adjustment fitting to slide freely (Figure 2).
3.
Shift the transaxle into 4th gear then into 3rd gear and then back into 4th gear. Leave gearshift lever in the 4th gear position and tighten crossover
cable adjusting screw to 70 in.lbs.
CAUTION:
DO NOT LEAN ON OR APPLY A LOAD TO THE SHIFT LEVER WHEN TIGHTENING THE ADJUSTING SCREW.
4.
Reinstall all hardware removed in Step 1.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No. 21-35-36-93 0.3 Hrs.
FAILURE CODE: 71 - Oil Leak
