dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Manual Transaxle - Locked in Neutral or Reverse|Page 4403 > < Manual Transaxle - Locked in Neutral or Reverse|Page 4397
Page 1
background image

Technical Service Bulletin # 212794

Date: 950203

Manual Transaxle - Locked in Neutral or Reverse

NO: 21-27-94
GROUP: Transmission
EFFECTIVE DATE: Feb. 3,1995

SUBJECT:
Manual Transaxle Locked in Neutral or Locked in Reverse

MODELS:
1990 - 1995 (AA) Spirit/Acclaim/LeBaron Sedan
1990 - 1993 (AG) Daytona
1990 - 1995 (AJ) LeBaron Coupe/LeBaron Convertible
1990 - 1994 (AP) Shadow/Shadow Convertible/Sundance
1990 - 1994 (AS) Caravan/Voyager
1992 - 1995 (ES) Chrysler Voyager (European Market)

NOTE:

THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A MANUAL TRANSAXLE.

SYMPTOM/CONDITION:
The manual transaxle is locked in neutral or locked in reverse after shifting out of reverse.

DIAGNOSIS:
If the operator of the vehicle describes this condition, perform the repair procedure. It is possible for the transaxle to "fix itself" because of vibration or
impacts experienced while being towed in for repair and could happen again if the repair procedure is not performed. A rotated detent roller or clutch
that is not fully disengaging will increase the chances of this condition happening.

Repair Procedure

REPAIR PROCEDURE:
This bulletin involves installing a stronger spring for the reverse detent.

Transaxle

1.

With the shifter in neutral, remove the lock pin on the gear shift housing and reinstall with the long end down (refer to Figure 1). If the transaxle is
not equipped with a lock pin skip to step 2.

2.

Remove the six bolts attaching the gear shift housing and remove and set aside the gear shift housing.

3.

Inspect ALL roller detents for improper alignment or damage. Properly align any misaligned roller detents and replace any damaged detents with
P/N 4531302.

Manual Transaxle - Locked in Neutral or Reverse|Page 4403 > < Manual Transaxle - Locked in Neutral or Reverse|Page 4397