Caravan FWD L4-2.4L VIN X (1997)
Exhaust Resonator: Service and Repair
REMOVAL
1. Raise vehicle on hoist and apply penetrating oil to clamp bolts and nuts of component being removed.
2. Remove clamps and supports from exhaust system to permit alignment of parts during assembly.
3. When removing tailpipe, raise rear of vehicle to relieve body weight from rear springs to provide clearance between pipe and rear axle parts.
4. Clean ends of pipes or muffler to assure mating of all parts. Discard broken or worn insulators, rusted clamps, supports and attaching parts. When
replacement is required on any component of the exhaust system. It is important that original equipment parts (or their equivalent) be used:
^
To insure proper alignment with other parts in the system.
^
Provide acceptable exhaust noise levels and does not change exhaust system back pressure that could effect emissions and performance.
INSTALLATION
1. Assemble pipes, muffler supports and clamps loosely to permit alignment of all parts.
2. Beginning at front of system, align and clamp each component to maintain position and proper clearance with underbody parts.
3. Tighten all clamps and supports to the proper torques and clearances.
