Caravan FWD V6-3.3L VIN R (2001)
Door Module: Service and Repair
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the appropriate door trim panel from the vehicle. Refer to Body for the procedure.
3. Remove the weather shield. Refer to Body for the procedure.
4. Disconnect the power door control module electrical connectors. Slide the red locking tab out (away from module) and depress connector retaining
tab, while pulling straight apart.
5. Remove the control module retaining screw.
6. Remove the module from the vehicle.
INSTALLATION
1. Position the control module and install the retaining screw.
2. Connect the control module electrical connectors. Slide the locking tab into the locked position.
3. Install the appropriate door trim panel on the vehicle. Refer to Body for the procedure.
4. Install the weather shield. Refer to Body for the procedure.
5. Connect the negative battery cable.
6. Using an appropriate scan tool, check and erase any power door control module diagnostic trouble codes.
7. Verify power door system operation. Cycle the power door through one complete open and close cycle.