Caravan FWD V6-3.3L VIN R (2001)
5. Remove secondary (yellow) retaining clip at rear of wheel speed sensor head.
6. Push up on metal retaining clip until it bottoms. This will release wheel speed sensor head from hub and bearing. While holding metal clip up, pull
back on wheel speed sensor head removing it from hub and bearing.
7. Remove wheel speed sensor assembly from vehicle.
INSTALLATION - WHEEL SPEED SENSOR (REAR - FWD)
CAUTION: Proper installation of wheel speed sensor cable is critical to continued system operation. Be sure that cable Is installed in routing
retainers/clips. Failure to install cable in retainers may result in contact with moving parts or over extension of cable, resulting in an open circuit.
NOTE: Make sure wheel speed sensor stays clean and dry as it is installed into the hub and bearing cap.
1. If metal sensor retaining clip is not in the neutral installed position on hub and bearing cap, install from the bottom, if necessary, and push clip
upward until it snaps into position.
2. Install wheel speed sensor head into rear of hub and bearing aligning index tab with the notch in the top of the mounting hole. Push the sensor in
until it snaps into place on the metal retaining clip.
3. Install secondary (yellow) retaining clip over wheel speed sensor head and engage the tabs on each side.
4. Route sensor cable under leaf spring along rear of axle. Install speed sensor cable into routing clips on rear brake flex hose.
5. Install cable into metal routing clip and attach it to the rear axle with mounting bolt. Tighten mounting bolt to 16 Nm (140 inch lbs.).
6. Connect wheel speed sensor cable to vehicle wiring harness. Be sure speed sensor cable connector is fully seated and locked into vehicle wiring
harness connector.
7. Install speed sensor cable grommet into hole in floor pan making sure grommet is fully seated into hole.
8. Lower vehicle.
9. Road test vehicle to ensure proper operation of the base and ABS braking systems.
