Caravan FWD V6-3.3L VIN R (2001)
Low Oil Pressure:
The chime will sound when the engine is operating and the oil pressure drops below 4psi/27.5kPa.
Engine Temperature Critical:
The chime will sound when the engine is operating and the coolant temperature exceeds 252 °F/122C or 234 °/112C(diesel). The chime is
continuous at 257 °F/125C and wilt chime for 4 minutes and stop if the temperature drops below 255 °F/123C.
Low Washer Fluid
The chime will sound when the washer fluid drops below a specific level.
Warning Lamp Announcement:
A chime will sound to alert the driver to scan the instrument panel to see which warning lamp is illuminated. The door/liftgate ajar warning
lamp will appear without a chime if the vehicle is running and a door or the liftgate is opened. A chime will sound if the door or liftgate is still
open and the vehicle speed is greater than 4mph/6kph.
High-speed warning (GCC)
The chime will sound, acting as a warning to the driver that the vehicle speed has exceed 75mph ± 2/120kph ± 3.
Warning Lamp Announcement
Low Fuel Lamp:
The cluster will request a single chime after the indicator is illuminated.
Volt Lamp:
The cluster will request a single chime after the indicator is illuminated.
Oil Pressure Lamp:
The cluster will request a single chime after illuminating the indicator above 450rpm vehicle operation.
Headlight Out Lamp:
The cluster will request a single chime after the indicator is illuminated.
Liftgate Ajar Lamp:
The BCM determines when to chime for liftgate ajar.
Fasten Seat Belt Lamp:
The BCM will request five chimes from the MIC when the ignition is turned to the unlock/run/start positions if the driver seat belt is not
buckled.
Check Engine Lamp:
The cluster will request a single chime after the indicator is illuminated.
Low Washer Fluid Lamp:
The cluster will request a single chime after the indicator is illuminated.
Engine Temperature Lamp:
The cluster will request a single chime when the indicator is first illuminated at 252 °F/122C.
Other Chime ON Conditions
Bulb Check:
The chime will sound three times during bulb check.
Programming of Additional Key Fob:
A double cluster chime will sound, an which signals that the program mode has been initiated.
Programming for Rolling Door Locks:
When the programming has been completed, a single tone from the chime system, will occur.