Caravan FWD V6-3.3L VIN R (2001)
1.
Adjust the lift gate striker forward (in car) in 2 mm increments until "pop off" is achieved. Do not let the lift gate become more then 3 mm
underflush to the body above the tail lamps.
2.
Power operate the PLG to open and then close with the RKE Fob or button in the overhead console. Perform Procedure A if the lift gate has
moved to 3 mm or more underflush to the body above the tail lamps without the lift gate opening in the power mode.
3.
Reset the PLG module obstacle detection values by cycling the PLG three times or by connecting the DRBIII(R) and selecting
Standalone/1998-2001 Diagnostics/Body/Power Lift Gate/Misc/Reset Module.
PROCEDURE 2C:
1.
Move the striker rearward 2 mm and remeasure flushness above and below the tail lamps. Flushness should improve above the tail lamps with no
change below the tail lamps.
2.
Power operate the PLG to open and then close with the RKE Fob or button in the overhead console.
3.
Add three lift gate bumper shims, p/n 05020315AA, behind the rubber bumper on each side of the lift gate opening.
4.
Add or subtract lift gate bumper shims as required to achieve a consistent fit side to side. The lift gate will remain overflush below the tail lamps.
5.
Reset the PLG module obstacle detection values by cycling the PLG three times or by connecting the DRBIII(R) and selecting
Standalone/1998-2001 Diagnostics/Body/Power Lift Gate/Misc/Reset Module.
