Caravan FWD V6-3.3L VIN R (2001)
3. Ensure the transaxle oil pan and transaxle case sealing surfaces are clean and dry. Install an 1/8" bead of Mopar Silicone Rubber Adhesive Sealant
to the oil pan and install (Fig. 385). Torque oil pan-to-transaxle case bolts (Fig. 386) to 19 Nm (165 inch lbs.).
4. Lower vehicle.
5. Connect transmission range sensor connector.
6. Install manual valve lever to manual shaft.
7. Install gearshift cable to manual valve lever.
8. Connect battery negative cable.
9. Fill transaxle with Mopar ATF +4 Transmission fluid.
Solenoid Body
REMOVAL
NOTE: If solenoid/pressure switch assembly is being replaced, it is necessary to perform the TCM Quick Learn Procedure.
1. Disconnect battery negative cable.
2. Remove air cleaner assembly.
3. Disconnect solenoid/pressure switch assembly connector.
4. Disconnect input speed sensor connector.