Challenger V6-3.5L (2009)
Yaw Rate Sensor: Service and Repair
Dynamics Sensor - Installation
INSTALLATION
1. Install dynamics sensor (3) over studs mounted to floor pan tunnel (4).
2. Install mounting nuts (2). Tighten nuts to 12 Nm (110 in. lbs.).
3. Connect wiring harness (1) connector to module (3).
4. Install floor console. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Installation
5. Connect negative battery cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
6. Perform Verification Test and clear any faults. See: Brake Bleeding/Service and Repair.