Challenger V6-3.5L (2009)
Cruise Control Switch: Service and Repair
Speed Control Switch - Installation
INSTALLATION
1. Install the speed control switch (2) to the steering wheel.
2. Install the two screws (1) to the rear of the speed control switch (2) and tighten to 1 Nm (9 in. lbs.).
3. Install the screw (1) to the front of the speed control switch (3) and tighten to 3.5 Nm (31 in. lbs.).
4. Connect the speed control switch electrical connector (2).
5. Install drivers airbagSee: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Air Bag - Installation.
6. Verify system operation.
7. Connect the negative battery cable.
