Challenger V6-3.5L (2009)
Headlamp Igniter Module: Service and Repair
High Intensity Discharge Ballast - Installation
INSTALLATION
1. Position the HID ballast module (1) near the mounting hole on the underside of the front lamp unit housing (4).
2. Reconnect the front lamp unit wire harness connector (2) and the high tension cable connector (3) to the module connector receptacles.
3. Position the ballast module (1) over the mounting hole of the lamp housing (2).
4. Install and tighten the four screws (3) that secure the ballast module to the underside of the front lamp unit housing. Tighten the screws securely.
5. Reinstall the front lamp unit into the vehicle. See: Lighting and Horns/Service and Repair/Front Lamp Unit - Installation.
6. Reconnect the battery negative cable.