Challenger V8-5.7L (2010)
NOTE: Always install a new hub nut. The original hub nut is one-time use only and should be discarded when removed.
38. On each side of vehicle, slide an axle half shaft (2) through hub and bearing and install hub nut (1). Do not tighten hub nuts at this time.
39. Install rear axle differential. .
40. While a helper applies brakes to keep hub from turning, tighten hub nut to 213 Nm (157 ft. lbs.).
41. Install rear exhaust system (2) (dual-outlet exhaust shown in figure).
42. Install tire and wheel assemblies (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.).See: Maintenance/Wheels and Tires/Service and
Repair/Removal and Replacement/Tires and Wheels - Installation