Challenger V8-5.7L (2010)
23. Lift the instrument panel assembly (2) off of the supports (1 and 5). Guide the steering column end (4) through the opening in the dash panel (3)
and remove the instrument panel through the passenger door.
24. If required, remove the spring nuts (1) from the dash panel.
Instrument Panel - Installation
INSTALLATION
WARNING: Disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, Occupant Classification
System (OCS), seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the
battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis
or service. This is the only sure way to disable the Supplemental Restraint System (SRS). Failure to take the proper precautions
could result in accidental airbag deployment and serious or fatal injury.
WARNING: Never strike or drop the Occupant Restraint Controller (ORC), as it can damage the impact sensor or affect its calibration. The
occupant restraint controller contains the impact sensor, which enables the system to deploy the supplemental restraints. If an
airbag control module is accidentally dropped during service, the module must be scrapped and replaced with a new unit. Failure
to observe this warning could result in accidental, incomplete, or improper supplemental restraint deployment and serious or fatal
injury.
CAUTION: On vehicles equipped with the Occupant Classification System (OCS), never replace both the Occupant Restraint Controller
(ORC) and the Occupant Classification Module (OCM) at the same time. If both require replacement, replace one. Then perform
