Challenger V8-5.7L (2010)
13. Place the new wire harness into position in the steering wheel back cover and snap the white connector into place (Figure 5).
14. Place the back cover into position on the steering wheel and install the steering wheel back cover retaining screws.
15. Install the speed control lever and connect the electrical connector (Figure 4).
16. Install the speed control lever back cover (Figure 3).
17. Connect the new audio control switches to the steering wheel wire harness and snap the switches into place on the steering wheel (Figure 6).
18. Align the splines on the steering wheel to the steering column shaft, then install the steering wheel.
19. Place a drop of thread locker onto the retaining bolt threads and install the steering wheel retaining bolt (Figure 2). Tighten the bolt to 52 ft.lbs. (70
N.m).
20. Connect the wire harness white connector to the steering wheel.
21. Connect the airbag module wires to the driver airbag module and place the module into position on the steering wheel.
22. Install the airbag module retaining bolts (Figure 1). Tighten both retaining bolts to 97 in. lbs. (11 N.m).
23. Connect the negative battery cable.
24. For Vehicles equipped with the "Auto-Up" front window feature, calibrate the door module using the following procedure:
a. Turn the ignition to the "Run" position.
b. Regardless of current window position, move the driver side front window upward until the window stalls in the full up position. Allow the
window motor to stall for at least 2 seconds before releasing the window switch.
c. Move the driver side front window downward until the window stalls in the full down position. Allow the window motor to stall for at least 2
seconds before releasing the window switch.
d. Move the driver side front window upward until the window stalls in the full up position. Allow the window motor to stall for at least 2 second
before releasing the window switch.
e. Repeat steps 24a. through 24d. to calibrate the module for the passenger side front window.
