Challenger V8-5.7L (2010)
Wheel Bearing: Service and Repair
Rear Hub and Bearing - Installation
HUB AND BEARING
NOTE: Before installing hub and bearing on end of axle half shaft, ensure isolation washer is present on end of half shaft. Inspect washer
making sure it is not worn or damaged. Washer can be installed in either direction on shaft.
1. Position hub and bearing bolts though rear of knuckle and parking brake support just enough to hold support in place as hub and bearing is
installed.
2. Slide hub and bearing onto half shaft. Place hub and bearing through brake support, onto knuckle, lining up mounting bolt holes with bolts.
3. Install four bolts (2) fastening hub and bearing in place. Tighten mounting bolts to 68 Nm (50 ft. lbs.).