Challenger SRT-8 V8-6.1L (2009)
NOTE: Due to short travel and low spring tension, it is not necessary to lock-out parking brake lever to service parking brake components.
11. Connect front parking brake cable (5) at connector (3) to right rear parking brake cable (4) (axle differential not shown).
12. Install screw (2) fastening cable (1) routing bracket to rear crossmember front flange (3).
13. Position lower rear wheelhouse shield (3) onto body of vehicle. Install nuts (1), bolt (2) and push-pins (4) securing lower rear wheelhouse shield to
body. Tighten nuts and bolt securely.
14. Lower vehicle until rear wheels are just above floor level.
15. Apply parking brake lever. Release lever, then reapply.