Challenger SRT-8 V8-6.1L (2009)
Hose/Line HVAC: Service and Repair
A/C Liquid Line - Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution . Failure to follow these instructions may result in serious or fatal injury.
NOTE: The A/C liquid line is serviced in two sections. The rear section of the liquid line is serviced as an assembly with the rear section of the
A/C suction line.
FRONT SECTION
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery.
3. Remove the air cleaner housing See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service
and Repair/Air Cleaner Body - Removal.
4. Raise and support the vehicle.
5. Remove the front belly pan See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Removal.
6. Remove the nut (3) that secures the front section of the A/C liquid line (4) to the A/C condenser (5).
7. Disconnect the A/C liquid line from the A/C condenser and remove and discard the dual plane seal.
8. Install plugs in, or tape over the opened liquid line fitting and condenser outlet port.
NOTE: LHD model shown. RHD model similar.
9. Lower the vehicle.
10. Remove the nut (1) that secures the front section of the A/C liquid line (2) to the rear section of the liquid line (3).
11. Disconnect the front section of the A/C liquid line from the rear section of the liquid line and remove and discard the dual plane seal.