Challenger SRT-8 V8-6.1L (2009)
7. Install the three nuts (1 and 3) that secure the HVAC housing to the engine compartment side of the dash panel (2). Tighten the nuts to 7 Nm (62
in. lbs.).
8. Connect the heater hoses to the heater core tubes.
9. Connect the A/C suction and liquid lines to the A/C evaporator See: Hose/Line HVAC/Service and Repair/A/C Liquid Line - Installation.
10. Install the fresh air inlet housing to the engine compartment side of the dash panel. See: HVAC Housing - Installation.
11. Reconnect the negative battery cable.
12. If the heater core was replaced, flush the cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
13. Refill the engine cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
14. Evacuate the refrigerant system See: Service and Repair/Refrigerant System Evacuate.
15. Charge the refrigerant system See: Service and Repair/Refrigerant System Charge.
16. Initiate the Actuator Calibration function using a scan tool See: Service and Repair/HVAC Actuator Calibration Procedure.