Challenger SRT-8 V8-6.1L (2009)
5. Remove the upper fascia trim cover (2) from the rear fascia (1).
6. Pull the tail lamp unit (1) straight out of the rear of the quarter trim panel (2) far enough to access and disconnect the body wire harness connector
from the lamp connector receptacle.
7. Remove the outer tail lamp from the vehicle.
CENTER
1. Disconnect and isolate the negative battery cable.
2. Open the deck lid (1).
3. Remove the close out cover (2) at each outboard end of the center tail lamp (3) by grasping the inside corner of the cover and pulling it toward the
hinge at the front of the deck lid far enough to disengage the two latch features that secure it to the inner deck lid reinforcement and the center tail
lamp housing.