Challenger SRT-8 V8-6.1L (2009)
Cabin Air Filter: Removal and Replacement
Particulate Air Filter - Removal
REMOVAL
NOTE: LHD model shown in illustrations. RHD model similar.
1. Remove the air inlet grille (1) from the wiper module screen (2) located near the dash panel in the engine compartment.
2. Open the filter door (3) on the top of the particulate air filter housing (4) located inside of the dash panel plenum (5).
NOTE: To aid in reinstallation, note the installed position of the particulate air filter prior to removal of the filter.
3. Remove the particulate air filter (1) from the particulate air filter housing (2) located inside of the dash panel plenum (3). Note the direction of air
flow indicated by an arrow (4) on the filter.
Particulate Air Filter - Installation
INSTALLATION
NOTE: The particulate air filter is labeled with "REAR OF VEHICLE" and an arrow to indicate air flow direction through the filter. Make
sure to properly install the particulate air filter. Failure to properly install the filter will result in the need to replace the filter sooner
than required by design.
NOTE: LHD model shown in illustrations. RHD model similar.