Challenger SRT-8 V8-6.1L (2009)
12. Reinstall all (4) mounting screws for the cooler.
NOTE:
Verify the machine screw is used on the aluminum A/C block on the top right, SRT models do not apply.
13. Remove the Air Box. Refer to the detailed removal procedures available in DealerCONNECT > TechCONNECT under: Service info > 9 - Engine >
Air Intake System > Body, Air Cleaner > Removal.
14. Siphon power steering fluid from pump reservoir.
15. Remove the power steering return hose connected to the steering reservoir and using a safety regulated rubber tipped blow gun, extract the remaining
power steering fluid in the tri-cooler at 5 psi (Fig. 4).
16. Remove the return hose from the cooler and discard.
17. Install new cooler to reservoir hose. Refer to the detailed Installation procedures available in DealerCONNECT > TechCONNECT under: Service
Info > 19 - Steering > Pump > HOSE, Power Steering, Return > Installation > COOLER TO RESERVOIR.
NOTE:
Keep the black inlet and outlet protective boots from the cooler they will be used in Step # 19.
18. Install new power steering gear to cooler hose. Refer to the detailed Installation procedures available in DealerCONNECT > TechCONNECT under:
Service Info > 19 - Steering > Pump > HOSE, Power Steering, Return > Installation > GEAR TO COOLER.