Challenger SRT-8 V8-6.1L (2009)
6. Slide caliper with pads (2) over brake rotor and align with knuckle.
7. Install caliper mounting bolts (1). Tighten bolts to 130 Nm (96 ft. lbs.) torque.
8. Remove jack from under spring link.
NOTE: Always install a new hub nut. The original hub nut is one-time use only and should be discarded when removed.
9. Install hub nut (1) on end of half shaft (2). While a helper applies brakes to keep hub from turning, tighten hub nut to 213 Nm (157 ft. lbs.) torque.
10. Verify proper adjustment of the parking brake shoes and adjust as necessary. See: Brakes and Traction Control/Parking Brake System/Parking
Brake Shoe/Adjustments
11. Install tire and wheel assembly (1) See: Service and Repair/Removal and Replacement/Tires and Wheels - Installation. Tighten wheel mounting