Challenger SRT-8 V8-6.1L (2009)
Oil Pressure Sensor: Service and Repair
Oil Pressure Sensor - Installation
INSTALLATION
NOTE: Apply Mopar(R) Thread Sealant with PTFE to the sensor threads before installing into the engine block.
1. Install the oil pressure sensor (1).
2. Connect the oil pressure sensor electrical connector (1).
3. Position the generator and install the upper mounting bolt finger tight.
4. Raise and support the vehicle.
5. Install the lower mounting bolts (1) and tighten to 55 Nm (41 ft. lbs).