Challenger SRT-8 V8-6.1L (2009)
Seat Belt Buckle: Service and Repair
Seat Belt Buckle - Installation
INSTALLATION
FRONT SEAT BELT BUCKLE
1. Position the front seat belt buckle onto the stud near the rear of the inboard seat cushion frame.
2. Install the retaining nut onto seat cushion frame. Tighten the nut to 43 Nm (32 ft. lbs.)
3. Connect the seat belt buckle electrical connector.
4. Install the seat cushion side shield.
5. Install floor console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor Console - Installation.
WARNING: Do not connect the battery negative cable See: Testing and Inspection/Component Tests and General Diagnostics . If the system test is
not performed first it may result in serious or fatal injury.
WARNING: Following successful completion of the Airbag System test procedure, the Occupant Classification System Verification Test must
be done using a scan tool and the appropriate diagnostic information.
REAR SEAT BELT BUCKLE
1. Position the rear seat belt buckle onto mounting studs (3).
2. Install retaining nut. Torque nut to 34 Nm (25 ft. lbs.).
3. Install rear seat cushion See: Body and Frame/Seats/Seat Cover/Service and Repair/Seat Cushion Cover - Installation.