Challenger SRT-8 V8-6.1L (2009)
2. Lubricate new O-ring on steering gear end of return hose with clean power steering fluid.
3. Lift gear end of return hose to return port on steering gear. Install return hose (2) to steering gear (1). Do not tighten tube nut at this time.
4. Route return hose along right side of engine cradle as shown. Position pressure hose (1) routing clamp over return hose (2) routing clamp, then
install screw (4) securing hoses to right side of engine cradle (3).
5. Tighten return hose tube nut at steering gear to 47 Nm (35 ft. lbs.).
6. Route cooler end of return hose (1) under headlamp mounting crossmember (3) as shown.
7. Place hose in routing clip (2) on cooling module.