Challenger SRT-8 V8-6.1L (2009)
![background image](/dodge/challenger_srt-8/v8-6.1l/Page-1946002.png)
6. Push small end of bellows (2) past groove (1) machined into inner tie rod.
7. Apply a small amount of Mopar(R) Lubriplate or equivalent uniformly to groove (1) in inner tie rod shaft. This allows for toe adjustment without
twisting bellows.
8. Pull small end of bellows outward until ridge inside bellows engages groove.
9. Install new clamp (1) over small end of bellows (3).
10. Using crimping pliers (2), crimp bellows clamp (1) at gear body.
11. Thread tie rod jam nut onto inner tie rod far enough to install outer tie rod.
12. Install outer tie rod See: .