Challenger SRT-8 V8-6.1L (2009)
overtighten Nut.
6. Remove special tool.
7. Install spring link-to-knuckle bolt (2) front-to-rear through knuckle and link, then install nut. While holding bolt head stationary, tighten nut to 138
Nm (102 ft. lbs.) torque.
8. Install rear spring and all components necessary to access it, except rear tire and wheel assembly on side of repair See: Suspension Spring ( Coil /
Leaf )/Service and Repair/Removal and Replacement/Rear Suspension Coil Spring(s) - Installation
9. Install rear brake rotor and components necessary to access it See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and
Repair/Removal and Replacement/Brake Rotor - Installation
10. Lower vehicle.
11. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
12. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolt.
13. Tighten spring link bolt at crossmember to 108 Nm (80 ft. lbs.).
14. Tighten shock absorber lower mounting bolt nut to 72 Nm (53 ft. lbs.).
15. Perform wheel alignment See: Alignment/Service and Repair
Rear Tension Link - Removal
REMOVAL
1. Raise and support vehicle, See: Wheels and Tires/Vehicle Lifting/Service and Repair.
2. On both sides of vehicle, remove wheel mounting nuts (3), then rear tire and wheel assembly (1).