Challenger SRT-8 V8-6.1L (2009)
14. Insert end of cable (1) through rear knuckle (3) and install mounting screw (2). Tighten screw to 8 Nm (71 in. lbs.) torque.
15. Install parking brake shoe support over hub and bearing mounting screws and onto face of knuckle.
16. Install shoe actuator lever (1) on end of parking brake cable (2). Make sure actuator lever is positioned with word "UP" facing outward.
17. Install parking brake shoes as well as all components necessary to access them. See: Brakes and Traction Control/Parking Brake System/Parking
Brake Shoe/Service and Repair/Installation
NOTE: Before installing hub and bearing on end of axle half shaft, ensure isolation washer is present on end of half shaft. Inspect washer
making sure it is not worn or damaged. Washer can be installed in either direction on shaft.
18. Install hub and bearing as well as all components necessary to access it. See: Wheel Bearing/Service and Repair/Rear Hub and Bearing -
Installation