Challenger SRT-8 V8-6.1L (2009)
29. Remove the screws holding the side cover (4) to the valve body and valve housing.
30. Remove the Line Pressure Regulating Valve assembly (1), Lubricating Pressure Regulating Valve assembly (2) and the 2-3 Overlap Regulating
Valve, Sleeve and Piston assembly (3) from the valve body.
31. Check all valves for ease of movement and shavings.
32. Remove the pressure supply valve (1) from the valve body.
Electrohydraulic Control Unit - Cleaning
CLEANING
NOTE: Fine and extremely fine metallic particles have been known affect valve operation in this transmission. While these particles may be to
small to see with the naked eye, they can cause flares, or momentary going into neutral, on shifts.
Clean and flush the valve housings, valves, plugs, springs, and separator plates thoroughly with a standard parts cleaning solution only. Do not use
gasoline, kerosene, or any type of caustic solution.