Challenger SRT-8 V8-6.1L (2009)
Clutch Disc: Removal and Replacement
Clutch Disc - Removal
REMOVAL
1. Remove transmission.
2. Mark pressure plate (1) and flywheel (2) for installation reference.
3. Insert Clutch Tool 10018 through the clutch discs (1) into the pilot bearing.
4. Loosen pressure plate (1) bolts evenly in a crisscross pattern. This will release spring pressure evenly and avoid pressure plate damage.
5. Remove pressure plate (1) assembly and independent disc from flywheel (2).
Clutch Disc - Installation
INSTALLATION
NOTE: If flywheel is replaced or removed apply thread sealer to the flywheel retaining bolts. This will prevent engine oil from leaking onto
the clutch.
1. Insert Clutch Tool 10018 (1) into pilot bearing.
2. Install independent clutch disc over clutch tool up against flywheel.
3. Install pressure plate assembly (2) over clutch tool up against flywheel and onto the dowel pins (3).