Challenger SRT-8 V8-6.1L (2009)
Clutch Master Cylinder: Service and Repair
Clutch Master Cylinder - Installation
INSTALLATION
1. Position the clutch master cylinder (5) onto the clutch/brake pedal assembly and install the two nuts (7). Tighten the nuts securely.
2. Connect the clutch slave cylinder hydraulic line (6).
3. Remove the previously installed plug and connect the brake/clutch fluid reservoir supply line (1).
4. Connect the clutch starter interlock switch harness connector (2).
WARNING: Always install a new clutch master cylinder pushrod retainer clip during installation of the clutch master cylinder. Failure to
install a new retainer clip may result in loss of vehicle control and serious or fatal injury.
5. Connect the clutch master cylinder pushrod to the clutch pedal lever (4) and install a new retainer clip (3).
6. Install the instrument panel reinforcement and steering column cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Steering Column Opening Cover - Installation.
7. Install the driver side instrument panel silencer See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Silencer Panel - Installation.
8. Reconnect the negative battery cable.
NOTE: While bleeding the clutch system be certain the clutch pedal returns to the most upright position. It may take as many as two hundred
clutch strokes to bleed the system.
9. Bleed the clutch system See: Service and Repair.