Challenger SRT-8 V8-6.1L (2009)
5. Install a new pinion flange nut. Using Flange Wrench C-3281 (1) and 41mm socket, torque nut to 245 Nm (181 ft. lbs.).
6. Use a torque wrench calibrated to measure low torque values (1) to measure rotating torque at the pinion flange (2). Verify the turning torque
matches the rotating torque as measured before removal of the original seal.
7. Install rear axle assembly. Refer to Rear Axle Installation. See: Service and Repair/Removal and Replacement/Installation