Challenger SRT-8 V8-6.1L (2009)
NOTE: If re-using the propeller shaft coupler-to-axle flange fasteners, save the washers.
6. Remove three propeller shaft coupler (2) -to-axle flange (1) fasteners.
NOTE: Do not pry on the slinger (2).
7. Using suitable pry bar (1) in the location shown, partially disengage halfshaft(s) from axle assembly.
8. If a drive-on hoist is used, position transmission jack (1) to rear axle assembly. If a drive-on hoist is not used, compress rear suspension using
screw-style under-hoist jack stands (2), then position transmission jack to rear axle assembly.