Challenger SRT-8 V8-6.1L (2009)
CAUTION: Never grasp halfshaft assembly by the inner or outer boots. Doing so may cause the boot to pucker or crease, reducing the service
life of the boot and joint. Avoid over angulating or stroking the C/V joints when handling the halfshaft.
CAUTION: Use care while handling/storing halfshaft assembly. Damage to the slinger can result from improper handling. If slinger gets bent
or damaged, straighten slinger to avoid contact with axle seal assembly.
15. Remove halfshaft from hub. Remove and inspect rubber isolation washer (1). Discard washer if rubber surfaces are worn away. Repeat on other
side if necessary.
16. Remove axle seals (3) using suitable seal removal tool.