Charger L4-135 2212cc 2.2L SOHC VIN B 2-bbl (1982)
Carburetor Intake Manifold Spacer: Technical Service Bulletins
Carburetor - Replacement Aluminum Spacer
Models
All 1978 Through 1982 Four Cylinders - 1.7L & 2.2L
Subject
Replacement Aluminum Carburetor Spacer
Index
FUEL
Date
April 25, 1983
No..
14-21-83
P-1196-C
This bulletin updates Technical Service Bulletin #14-30-82 which should be retained in your files. A note has been added to Step 6 on page 2, of the
service procedure, providing instructions to check and, if necessary, correct for a warped carburetor flange condition.
A new aluminum carburetor spacer will be incorporated into production for the 1983 model year. This aluminum spacer may be used on all subject
model engine applications in place of the rubber isolator. The following installation procedures must be used to install the aluminum spacer in place of
the rubber type.
FIGURE 1 - ALUMINUM ISOLATOR KIT PN 4293755 COMPONENT PARTS
To install the replacement aluminum spacer, follow the simple bolt-on procedure outlined below:
PARTS REQUIRED
Carburetor Spacer Package PN 4293755
Contents of Kit:
1 - Spacer Assembly
PN 4268820
1 - Insulator
PN 4179302
1 - Carburetor Flange Gasket
PN 4095975
2 - Screw
PN 6100265
IMPORTANT:
SOME 1978 AND 1979 SUBJECT MODEL VEHICLES (WITH 1.7 ENGINE ONLY) MAY BE EQUIPPED WITH A
CARUBRETOR SERVICE PACKAGE, INSTALLED PER TECHNICAL SERVICE BULLETIN #14-12-79. THIS PACKAGE
INCLUDES A CARBURETOR INSULATOR PN 4105153 THAT MOVES THE PCV HOSE