Charger V6-2.7L (2008)
Thermostat: Service and Repair
Engine Coolant Thermostat - Installation
2.7L ENGINE
1. Clean gasket sealing surfaces.
NOTE: Install thermostat with the bleed valve located at the 12 o'clock position, between tabs on seal.
2. Install thermostat (4) and O-Ring (2) into thermostat housing (1).
3. If removed, install two studs (3).
4. Install thermostat (4) , thermostat housing (1), O-ring (2) and bolt. Tighten attaching bolts to 12 Nm (105 in. lbs.).
5. Lubricate new heater return tube O-ring with coolant.
6. Position heater return tube flange over two studs. Install nuts (3). Tighten retaining nuts (3) to 6 Nm (53 in. lbs.).
7. Tighten starter bolt to 54.3 Nm (40 ft. lbs.).
8. Connect the lower radiator hose to the thermostat housing (1). Install hose clamps.
