dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine Controls - MIL ON/DTC P050D/Cold Start Rough Idle|Page 5642 > < Engine Controls - Speedometer Needle Fluctuation|Page 5637
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL ON/DTC P050D/Cold Start Rough Idle

NUMBER: 18-048-07

GROUP: Vehicle Performance

DATE: November 16, 2007

THE StarSCAN(R) FLASH FILES FOR THIS BULLETIN MUST BE RETRIEVED FROM THE INTERNET.

StarSCAN(R) SOFTWARE LEVEL MUST BE AT RELEASE 8.03 OR HIGHER FOR THIS BULLETIN.

StarMOBILE STANDALONE MODE OR StarMOBILE DESKTOP CLIENT MAY ALSO BE USED TO PERFORM THIS PROCEDURE.

SUBJECT:

Flash: MIL Illumination Due To Diagnostic Trouble Code P050D - Cold Start Rough Idle Or Delay At Initial Throttle Tip In From A Stop

OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software.

MODELS:

2008

(LX)

300 / Magnum / Charger

NOTE:

This bulletin applies to the above listed vehicles equipped with a 2.7L engine with a 42 RLE transmission (sales code EER and DGV) built before
November 13, 2007 (MDH 1113XX).

SYMPTOM/CONDITION:

The vehicle operator may experience one or both of the following:

^

P050D - Cold Start Rough Idle

^

Delay At Initial Throttle Tip In From A Stop

DIAGNOSIS:

Using a Scan Tool (StarSCAN(R)) with the appropriate Diagnostic Procedures available in TechCONNECT, verify all engine systems are functioning as
designed. If other DTC's are present record them on the repair order and repair as necessary before proceeding further with this bulletin.

If the vehicle operator describes or experiences the Symptom/Condition, perform the Repair Procedure.

PARTS REQUIRED:

Engine Controls - MIL ON/DTC P050D/Cold Start Rough Idle|Page 5642 > < Engine Controls - Speedometer Needle Fluctuation|Page 5637