Charger V6-3.5L (2009)
Repair/Procedures/Battery Reconnection
46. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
47. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolts.
48. Tighten shock absorber lower mounting bolt nuts (4) to 72 Nm (53 ft. lbs.).
49. Perform wheel alignment, paying special attention to thrust angle. If rear crossmember needs to be shifted to align thrust angle, try to avoid
compromising tension link clearance (Refer to 22 ). See: Maintenance/Alignment/Service and Repair
Spring Link
INSTALLATION
1. Position bushing (1) over rear of crossmember bushing bore.
2. Assemble tools over bushing and crossmember as shown (See list). Ensure Receiver, Special Tool 9032-3, is positioned to avoid welds on rear of
crossmember bushing bore.
-
(2) Remover/Installer 9032-2
-
(3) Press C-4212F
-
(4) Receiver 9032-3
3. Tighten Press screw-drive, pressing bushing into crossmember. Install bushing until screw-drive stops, when bushing contacts Receiver on
opposite side of crossmember.
4. Remove tools.