Charger V6-3.5L (2009)
will come off when bolt is removed. Discard these washers; install NEW washers on installation.
6. While holding guide pins from turning, remove caliper guide pin bolts (1).
7. Remove brake caliper (3) from brake adapter (2) and pads.
Rear
INSTALLATION
CAUTION: Always inspect brake pads before installing disc brake caliper and replace as necessary. See: Brake Pad/Service and
Repair/Procedures/Brake Pads - Inspection
1. Completely retract caliper piston back into bore of caliper. Use hand pressure or a C-clamp may be used to retract piston, first placing a wood
block over piston before installing C-clamp to avoid damaging piston.
CAUTION: Use care when installing caliper onto disc brake adapter to avoid damaging boots on caliper guide pins.
2. Push caliper guide pins into caliper adapter to clear caliper mounting bosses when installing.
3. Slide caliper over brake pads and onto caliper adapter (3).
CAUTION: Extreme caution should be taken not to crossthread caliper guide pin bolts (2) when they are installed.
NOTE: Before installing caliper guide pin bolts, clean guide pin bolt threads and apply Mopar(R) Lock & Seal Adhesive or equivalent.
4. Align caliper mounting holes with guide pins, then install guide pin bolts (2). While holding guide pins from turning, tighten bolts to 31 Nm (23 ft.
lbs.).