Charger V6-3.5L (2009)
5. Install banjo bolt (6) attaching brake hose (1) to caliper (5). Install NEW washers (7) on each side of hose fitting as banjo bolt is placed through
fitting. Thread banjo bolt into caliper and tighten to 50 Nm (37 ft. lbs.).
6. Install tire and wheel assembly (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.). See: Maintenance/Wheels and Tires/Service and
Repair/Removal and Replacement/Tires and Wheels - Installation
7. Lower vehicle.
8. Remove brake pedal holding tool.
9. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
Repair/Procedures/Battery Reconnection
